Wear of aluminium alloys

内容节点: 概述; 实验/设备条件; 样品提取; 实验/操作方法; 实验结果/结论; 仪器/耗材清单

Introduction The Tribology Group in the Department of Materials Technology (formerly the Metallurgy Department) at Brunei University has been active since the late I960s. Most of the early work was on dry wear of both steels and cast irons. It was a logical development when work commenced in the middle 1970s on lubricated wear of materials. particularly those used in the internal combustion engine. This work was supported by SERC and Esso Petroleum Ltd and later Esso Chemical Ltd. During this period. two students obtained PhDs and another has recently submitted a thesis for examination. all concerned with lubricated wear of steel and cast iron engine components. It became quite clear towards the middle 1970s that other materials in both bulk form and as surface coatings would become important as the drive for lighter weight and improved fuel efficiency gathered speed. TE 99 通用摩擦磨损试验机

相关产品

您可能感兴趣的解决方案

OXIDATIVE WEAR OF ALUMINIUM ALLOYS

Summary Pin-on-discexperiments were carried out to
Localized Corrosion Growth Kinetics in

The kinetics of localized corrosion in AA2024 alloys w
COAT-SCRATCH-WEAR Mechanical, electroc

Mechanical,electrochemical and tribological properties
COAT-SCRATCH-WEAR Mechanical and elect

This paper reports our recent studies on nanocrystalli
Nanoindentation, microscratch, frictio

A nanoscale monolithic slider-suspension produced by p
Wear of Cobalt and a Nickel Alloy

The wear characteristics of a nickel-base alloj h
Wear Disgnosis by Metallurgical Meams

With the increased pressure being put on matericals us
Wear mechanisms

Wear is discussed in terms of its damaging affect
Wear Characteristics of piston Rings

Wear of piston rings and cylinder liners has been ex